Allnet ALL9600R Manuel d'utilisateur télécharger pdf (Page 11)

(4) Connect UTP Cable: Plug two ends of UTP cable to Transmitter and

Receiver’

RJ45 UTP link ports, the Receiver’s connected monitor

and speaker should work now. You can adjust the FOCUS and GAIN

control of Receiver to have the best VGA display.

(5) Function Test: After above installation, you will be able to broadcast the

AV signal to Receiver’s connected monitor and speaker.

(6) Problem and Solving: If you find unstable image or audio problems

after installation, please confirm following list or contact your direct

vendor for further assistance:

a. Check if PC’s VGA resolution and frequency over the limit of monitor

display, if so, please change the VGA configuration from Windows

Control panel.

b. Try to connect Monitor and speaker directly to a PC, and ensure the

basic function of these devices.

c. When using LCD or same type monitor, there might have some image

offset or blinking, please adjust the position, clock or phase of the

LCD monitor, or simply press Auto Adjust / Tune to have a better

image solution.

3. Other Integration and Application

Please contact your local dealer or vender for further information.

One-Port Transmitter One-Port Receiver

VGA output Devices

Projector PDP LCD CRT

Use Cat5e cable

Max : 300M

VGA Audio USB

3-in-1 Cable

Installation Diagram of Receiver ALL9600R

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Allnet ALL9600R Manuel d'utilisateur Page 11